When applying the stickers ensure that the ski surface is clean and dry; press firmly on the sticker at room temperature and leave overnight before skiing.
Use a sharp blade to lift off the (red) protective film from the sticker. Be careful not to remove the sticker itself from the base tag.
Make sure you also use the screws in conjunction with the stickers. We suggest drilling a small hole for each screw and applying a little wood glue into the created hole before applying the screws. This will ensure there can be no water ingress into the ski.
RESQSKI has been designed specifically for a long battery life.
The handheld takes one CR2032 battery. The tags take two LR54 batteries each.
Estas baterías son fácilmente disponibles y baratos. Please ensure you buy reputable branded batteries.
We strongly recommend that you take out the Homing tag batteries at the end of the season and replace them at the start of the next season. This is because any leakage from old batteries will destroy the Homing tag internal parts.
1. Place the tag on a flat surface and take out the screws. Carefully lift the lid without disturbing the lower part of the tag.
2. Remove the batteries and check the black rubber seal and the battery terminal is in good order and in place.
3. Place new batteries with the positive + face down on the right hand side; negative – to the left.
4. Carefully replace the lid in the same position and tighten the screws (do not over-tighten).
5. Inspect the underside of the tag to check the screws are properly attached to the nuts. Test in the base tag that the light comes on when turned to ‘on’.
RESQSKI no debe interferir con el funcionamiento de los transceptores de avalancha.
Transceptores de avalancha operar a 457 KHZ. RESQSKI operates at frequency 2.45 GHZ.
